Rain Diverter Kit
£10.99
Rain Diverter Kit collects the water that falls on your house roof, shed or greenhouse automatically from your rain down pipe. Fits standard 68mm round or 65mm square plastic down pipes (not suitable for cast iron down pipes). BEWARE Do not use an electric drill if the Butt contains any water.
Fitting Instructions:
- Take the lid off the water butt. If your water butt is not predrilled then you will need to drill a 25mm hole to fit the rain diverter.
- Drill a 25mm hole near the top of the water butt on the side closest to the down pipe (some water butts may have drill points indicated). Push connector through the washer from inside the butt, then fit and tighten the nut on the outside to form a seal.
- Position water butt with tap facing forward and adjust to down pipe. If using a stand place the butt on it. Mark the down pipe 10mm below the top of the butt. Mark again 30mm below this point, using a hacksaw. Cut out this section.
- Fit rain diverter with square end up into the cut section of the down pipe. Release any clips supporting the down pipe in order to insert the rain diverter body and refit once diverter is in place.
Connect hose between rain diverter kit body and the water butt connector.
If you would like to view more of the water butt range, please click here. Alternatively, please visit one of our 5 stores to see the full range of watering equipment available.
This product is supplied by Garland. To find out more about this company and view their full range of products, please visit their website here.
This product is available at the following garden centres:
- Alexandra Palace Garden Centre & Café
- Neal's Nurseries Garden Centre
- Sheen Garden Centre
- Sherfield-on-Loddon Garden Centre & Café
- Studley Green Garden Centre
- Woods of Berkhamsted Garden Centre & Café
Products stocked will vary at each centre.
We will be pleased to order out of stock items but this will be dependent on the availability from the supplier.
Products can be purchased 'in-store ' only
